The steel wire mesh produced by wire mesh factories in China meets the quality standards: steel wire mesh in shape and steel wire welding in customization. The shape and size of the reinforcing bar net shall be determined by negotiation between the two parties according to the design and construction requirements.

　　形状网格钢板钢筋在两个方向,但是可以在同一个方向和直径间隔导致钢筋应相同的快捷方式,间隔二世,crb550应采用钢丝网肋下冷轧hrb400级或钢肋下热轧级钢筋的生产,cpb550可能采用光冷拉级钢筋生产。注:网孔钢筋技术应符合现行《钢筋混凝土网孔》gb/t-1499.3 2002的标准要求。

　　The shape grid steel bar is in two directions, but it can lead to the same shortcut in the same direction and diameter interval. The second time interval, the production of cold-rolled HRB400 grade steel bar under steel mesh rib or hot-rolled grade steel bar under steel rib should be adopted in crb550, and the production of cold-rolled grade steel bar under steel rib may be used in cpb550. Note: The technology of mesh reinforcement should meet the national standard requirements of gb/t-1499.3 2002.

　　钢网片的规格应符合以下规定:网片长度为12米，宽度不得超过3.3米。在小车方向上制作钢网适宜的间隔为100mm、150mm和垂直生产;200毫米间距的钢筋应具有补救'降水10毫米为所有排水。网格是纵向加筋的，可以实现加筋形式。双层钢筋，雨间距应力钢筋应不大于10mm。

　　The specifications of the steel mesh shall meet the following requirements: the length of the mesh shall be 12 meters and the width shall not exceed 3.3 meters. The most suitable spacing for making steel mesh in the direction of trolley is 100mm, 150mm and vertical production; the steel bar with 200mm spacing should have the ability to remedy the'precipitation 10mm'for all drainage. The grid is longitudinal stiffened and can be realized in the form of stiffening. Double-layer steel bar, rain spacing stress steel bar should not be more than 10 mm.

　　钢条直径:冷轧带轻拉拔或钢筋表面长度为12mm与钢条、冷加4比4的钢条工人直径在12mm范围内0.5 mm采用受力钢条驾驶座5-12mm;热轧带肋钢驾驶座的吃水为6-16毫米。钢筋网片的钢筋强度不应低于标准强度。95%保证率冷轧带肋钢筋和冷拔钢筋的强度按极限规程的标准值端口FSTK表示，确定强度。热轧带肋钢筋的强度标准值是根据fyk、抢取率确定的。

　　Bar diameter: cold-rolled strip light drawing or steel bar surface length of 12 mm and steel bar, cold-added 4:4 steel bar worker diameter in the 12 mm range of 0.5 mm force steel bar driver 5-12 mm; hot-rolled ribbed steel driver's draught is 6-16 mm. The reinforcing bar strength of steel mesh should not be lower than the standard strength. The strength of cold-rolled ribbed steel bar and cold-drawn steel bar with 95% guaranteed rate is expressed by the standard port FSTK of limit specification, and the strength is determined. The strength standard value of hot-rolled ribbed bar is determined according to fyk and grabbing rate.