The lap length of the two welded mesh and steel bar lap joints shall not be less than 1.3 times of the small anchorage length, and shall not be less than the lap area of 200 mm. The transverse reinforcement of each welded mesh shall not be less than one, and the interval between the two mesh and the transverse reinforcement shall not be less than 50 mm.

　　当搭接区域的两个钢网片中的一个没有横向钢筋时，加筋钢网片的较小搭接长度应是较小锚固长度la的1.3倍，且不应小于300mm。当粘结区纵向应力钢筋直径d≥10mm时，应增加粘结长度5d。

　　When there is no transverse reinforcement in one of the two steel meshes in the overlapping area, the smaller overlapping length of the reinforced steel mesh shall be 1.3 times of the smaller anchoring length La, and shall not be less than 300 mm. When the diameter D of the longitudinal stress reinforcement in the bonding area is ≥ 10 mm, the bonding length shall be increased by 5 days.

　　未来钢网设备的检验方法:钢网铺装的主要工序是:钢网焊接后应按设计图纸定位——网片设备——网片——检验与检验。钢网铺装的道工序是:设备底网-附加垫网或钢设备-支撑面网铺装-垂直和水平面网铺装-附加网和钢设备。

　　Inspection method of steel mesh equipment in the future: the main process of steel mesh pavement is: after the steel mesh is welded, it should be positioned according to the design drawings - mesh equipment - mesh - Inspection and inspection. The first process of steel net pavement is: equipment bottom net - Additional mat net or steel equipment - supporting surface net pavement - vertical and horizontal surface net pavement - additional net and steel equipment.

　　在网的底部敷设时，约主要注意应坐在薄膜的下面，当网的表面敷设主杆约在薄膜的顶部时。当相邻两网重叠时，应以重叠区域的和两端为绑扎牢固的铁丝，绑扎点不应小于3。附加的钢筋和焊接网的每个接头都是用铁丝制成的。

　　When laying at the bottom of the net, the main attention should be paid to sitting under the film, when the main pole of the net is laid at the top of the film. When the two adjacent nets overlap, the center and both ends of the overlapping area shall be bound firmly with iron wire, and the binding point shall not be less than 3. Each joint of the additional reinforcement and welded mesh is made of wire.