The steel mesh is made by binding or welding the transverse and longitudinal reinforcement
In order to ensure the engineering quality, welded steel mesh is produced by automatic and intelligent production line under strict quality control of the factory. Strictly control the grid size, steel bar specification and quality. It can avoid missing manual binding net, binding is not firm, binding error, cutting off work and materials. The mesh rigidity is big, the elasticity is good, the spacing is uniform and accurate, the welding point strength is high, and the engineering quality is greatly improved.
In order to improve the anti-seismic and anti cracking performance of reinforced concrete structure, the longitudinal and horizontal bars of welded steel mesh form a mesh structure, which has good bond anchorage performance with concrete, and the load distribution is uniform, which can significantly improve the seismic and crack resistance performance of reinforced concrete structure. According to the actual test, more than 75% of the cracks can be reduced by laying welded steel mesh on the road.
The ground reinforcement mesh is mainly used in bridges, highways, construction sites, buildings, tunnels, airport runways, walls, floors, etc.
The following Jinan Steel wholesale for you to introduce the characteristics of steel mesh.
Features of ground reinforcement mesh:
Ensure the quality of the project. Improve the anti-seismic and anti cracking performance. Save the amount of reinforcement. To speed up the construction progress, the use of fine steel mesh can speed up the construction speed of the project. As long as the welded steel mesh is laid according to the requirements, the concrete can be poured, and the links such as site reinforcement selection, pouring one by one and binding are omitted.
The design strength of welded mesh reinforcement is 50% to 70% higher than that of grade I reinforcement (plain welded mesh). Considering some structural requirements of the bridge reinforcement mesh, the reinforcement can still be saved about 30%, and the processing cost of loose reinforcement with diameter less than 12mm is about 10% - 15% of the material cost. The results show that the reinforcement cost can be reduced by about 10% after considering the reinforcement mesh.
The above is about the steel mesh structure and characteristics of the relevant introduction, I believe that you have understood, want to know more content, welcome to pay attention to Jinan Steel wholesale http://www.jzqgc.com Official website.